Product Recalls

Product Under Safety Recall Notice

M&P AR-15 Rifle Lower Parts Kit Complete (Item #110114), supplied by Battenfeld Technologies, Inc.

Description of the Hazard

Due to an error in the packaging process, certain M&P AR-15 Rifle Lower Parts Kit Complete (Item #110114) supplied by Battenfeld Technologies, Inc. may have included a hammer with a missing pin that keeps the hammer pin in place, making the hammer unsuitable for use with certain rifles. The use of an incorrect hammer assembly may lead to a failure of the rifle to function as intended, including a potential risk of an unintended discharge.

Description of the Product Involved

This recall applies to all M&P AR-15 Rifle Lower Parts Kit Complete (Item #110114) supplied by Battenfeld Technologies, Inc. prior to September 12, 2017

This recall does NOT include S&W factory produced complete M&P rifles.

Remedy/Action to be Taken

DO NOT ASSEMBLE A RIFLE USING THIS M&P15 COMPLETE LOWER PARTS KIT. IF YOU HAVE ALREADY DONE SO, STOP USING THE RIFLE IMMEDIATELY.

Any unintended discharge of a firearm has the potential to cause injury. We are asking all purchasers of the M&P AR-15 Rifle Lower Parts Kit Complete to refrain from assembling a rifle using the hammer from the kit. If you have already done so, immediately stop using the rifle until corrective action can be taken.

To facilitate this repair, please contact Battenfeld Technologies, Inc. at the number below to arrange for the return and replacement of the M&P AR-15 Rifle Lower Parts Kit Complete, or the hammer only from the kit.

When you return the hammer, we will replace it with a new part at no cost to you. Your hammer will be returned as quickly and efficiently as possible. Remember, while you are awaiting the replacement hammer, any rifle assembled with an M&P AR-15 Rifle Lower Parts Kit Complete should NOT be used. The lower receiver should be disassembled and the rifle should be stored unloaded and with the safety in the SAFE LOAD/UNLOAD position.

Please do NOT return firearms or receivers to Battenfeld Technologies, Inc. Firearms or receivers received by Battenfeld will be returned to sender WITHOUT remedial action. The M&P AR-15 Rifle Lower Parts Kit Complete with the replacement hammer will be identified as Item #1085634.

For hammer-only replacements, you should note a J pin as shown in the photo below. This J pin is confirmation that your hammer has been replaced.

Consumer Contact:

To arrange for the replacement of the hammer, email us at recall110114@btibrands.com or call us at (877) 416-5167. Your hammer will be returned as quickly and efficiently as possible.

IF YOU HAVE ANY QUESTIONS ABOUT THIS RECALL, PLEASE CONTACT BATTENFELD TECHNOLOGIES, INC. AT (877) 416-5167.

Support

  • Contact Customer Service

    Visit our Customer Service page to contact us with specific questions via email:

    Visit Customer Service
  • Our Contact Information

    BY EMAIL:

    CustomerService@btibrands.com

    TELEPHONE:

    877-509-9160
    Mon-Fri *8:00AM-5:00PMĀ CentralĀ Time

    FAX:

    573-446-6606

    MAILING ADDRESS:

    Battenfeld Technologies Inc.
    2501 Lemone Industrial Blvd,
    Columbia, MO 65201